Damatech
High Performance SteelValue Added ProcessingInnovative Industrial SolutionsDamatech

Induction and Laser Hardening

Laser hardeningq

Hard Cutting Edge. Tough Core. Increase cutting-edge hardness while maintaining the toughness of the knife body.

For industrial knives, hardness is essential for maintaining a sharp and wear-resistant cutting edge. At the same time, the knife body must remain tough enough to withstand impact, shock loads and repeated mechanical stresses.

Toolox® 44 and Toolox® 46 provide an excellent base material for industrial knives that require additional localized hardening of the cutting edge.

Cutting-edge hardness up to 56–59 HRC

Using induction or laser hardening, selected areas of Toolox® 44 and Toolox® 46 can be locally hardened to approximately 56–59 HRC.

Only the cutting edge or other wear-exposed areas are hardened, while the rest of the component retains the original properties of Toolox®. This creates an effective combination of a hard, wear-resistant cutting edge and a strong, tough knife body.

Induction hardening – deeper hardened layer

Induction hardening is particularly suitable where a relatively deep hardened zone is required. Depending on the geometry and process parameters, hardening depths of up to approximately 4 mm can be achieved.

The process is well suited for industrial knives, blades and other components exposed to intensive wear and high mechanical loads.

Laser hardening – precise and localized

Laser hardening provides highly controlled heat input and allows specific areas of a component to be hardened with high precision. Typical hardening depths can reach approximately 1.5 mm, making laser hardening particularly suitable for cutting edges and localized wear surfaces where precise treatment and limited thermal influence are important.

An efficient solution for industrial knives

The combination of Toolox® 44 or Toolox® 46 with localized surface hardening offers an attractive solution for demanding industrial knife applications.

Instead of hardening the complete component, only the areas where additional hardness is actually required are treated.

The result is:

High cutting-edge hardness. Excellent wear resistance. Tough and reliable knife body.

Through our specialized subcontracting partners, Damatech can coordinate induction and laser hardening as part of a complete manufacturing solution – from Toolox® material and cutting to machining and final surface hardening.