Damatech
High Performance SteelValue Added ProcessingInnovative Industrial SolutionsDamatech

Stamping Tools

Components for Stamping Tools

Components for Stamping Tools

Greater dimensional stability. Higher precision. Shorter production time.

Modern stamping dies require high precision, reliable performance and excellent dimensional stability. Toolox® pre-hardened engineering and tool steel offers an efficient solution for manufacturing die base plates, intermediate plates and other highly loaded stamping tool components.

Toolox® is delivered quenched and tempered, with guaranteed hardness, toughness and consistent properties throughout the plate. Since additional heat treatment is normally not required, the risk of distortion and dimensional changes during tool production is significantly reduced.

Toolox® 33 for precision die base plates

Toolox® 33 is particularly suitable for base plates used in stamping dies that produce components with extremely tight tolerances. Its excellent dimensional stability enables precise machining and helps maintain the required geometry throughout production and operation. Compared with conventional pre-hardened steel such as 1.2312, Toolox® 33 provides significantly better dimensional stability. This is especially important for large or complex base plates, where even minor distortion can affect the alignment of the complete die and the accuracy of the stamped components.

The homogeneous properties and low residual stresses of Toolox® 33 offer several important benefits:

•High dimensional accuracy after machining

•Reduced risk of plate distortion

•Precise alignment of punches, dies and guiding elements

•Reliable production of parts with extremely tight tolerances

•Less corrective machining and shorter tool assembly time

•Improved reliability during maintenance and component replacement

Toolox® 33 combines good machinability with the strength and stability required for robust, high-precision die structures.

Toolox® 44 for intermediate plates

Intermediate plates are exposed to high mechanical loads and must reliably transfer forces between different parts of the stamping die. Toolox® 44 provides the higher hardness, strength, fatigue resistance and toughness required for these demanding components. Because Toolox® 44 is supplied pre-hardened and ready for machining, intermediate plates can be produced without conventional hardening and subsequent correction of heat-treatment distortion. This simplifies the manufacturing process and improves dimensional accuracy.

Toolox® 44 is an excellent choice for intermediate plates where higher mechanical strength and resistance to repeated loading are required. It helps maintain the rigidity and alignment of the die while reducing the risk of cracking or premature component failure.

A complete material solution for stamping dies

The combination of Toolox® 33 for dimensionally stable base plates and Toolox® 44 for highly loaded intermediate plates provides an efficient material concept for precision stamping dies.

By eliminating additional heat treatment, Toolox® helps toolmakers reduce production time, minimise distortion and lower overall manufacturing costs. The result is a more accurate and reliable stamping tool with faster commissioning and consistent performance throughout its service life.

Higher precision. Greater stability. Faster tool production.