Damatech
High Performance SteelValue Added ProcessingInnovative Industrial SolutionsDamatech

Bending Tools

Toolox Press Brake Bending Tools

Bending Tools for Press Breaks

Greater dimensional stability. Faster production. Nitrided to 700 HV.

The production of long and precise press brake tools places exceptionally high demands on the selected steel. Even minor dimensional changes during machining or surface treatment can affect tool alignment, bending angles and the accuracy of finished components. Toolox® 33 provides a high-performance alternative to conventional pre-hardened steel 1.2312. Its superior dimensional stability and homogeneous properties make it particularly suitable for manufacturing press brake dies and segmented bending tools.

Superior dimensional stability

Toolox® 33 is supplied quenched and tempered, with carefully controlled properties and low residual stresses throughout the material. This helps press brake tools maintain their geometry during machining and subsequent manufacturing operations. Compared with 1.2312, Toolox® 33 offers significantly better dimensional stability.


The improved dimensional stability provides:

More accurate tool geometry

•Consistent bending angles along the entire tool length

•Precise alignment between the punch and die

•Less straightening and corrective machining

•Faster assembly and commissioning

•Reliable production of components with tight tolerances

Faster tool production

Toolox® 33 is delivered pre-hardened and ready for machining. Press brake tools can therefore be machined directly to their final geometry without additional through-hardening.

Eliminating conventional hardening shortens the manufacturing process and reduces the risk of distortion, dimensional changes and cracking. Toolmakers benefit from a faster and more predictable production process, with less time required for corrections and finishing.

Compared with 1.2312, Toolox® 33 offers improved dimensional stability while retaining good machinability and suitability for large, long and geometrically demanding press brake tools.

Nitrided surface hardness of 700 HV

After machining, Toolox® 33 press brake tools can be nitrided to achieve a surface hardness of approximately 700 HV. The nitrided layer increases resistance to wear, indentation and surface damage in areas exposed to high contact pressure and repeated use.

The result is a hard, wear-resistant surface supported by a strong and dimensionally stable Toolox® 33 core. This combination helps the tool retain its geometry and functional surfaces over a longer operating period.

A faster route to accurate press brake tooling

Toolox® 33 combines excellent dimensional stability, good machinability and suitability for nitriding in a ready-to-use material. As a replacement for 1.2312, it enables faster tool manufacturing, reduces the need for corrective machining and supports consistently accurate bending results.

More dimensionally stable than 1.2312. Faster to manufacture. Nitrided to 700 HV for improved wear resistance.

From Steel to Finished Component, Faster and More Efficiently