Injection molds

Case Study: Toolox Injection Mould

Initial situation: As an injection mould, a cable capsule made of nylon PA with 15% glass fibers was produced. This is a second-form mould for direct injection molding. The shaping parts were made from Toolox 44.

Test: The test mould was prepared in the standard hardness of 45 HRC and then ionically nitrated to the hardness 61 62 HRC.

Result: Around 10,000 pieces a month were produced, until the total number of 50,000 pieces was reached and the production of the cable capsule was discontinued. The mould made from Toolox is still fully functional.

See also:


Contact us

Send us a message and we will reply as soon as possible.

Damatech d.o.o.
  • Cesta Franceta Prešerna 63
  • SI-4270 Jesenice, Slovenia
  • T: +386 5 923 55 00
  • F: +386 5 923 55 01
  • E: